Exhaust Hood HTD5405 for TAYLOR'S 079D | TOPLICHT

To be able to use the full range of Shopware 6, we recommend activating Javascript in your browser.

Jobs

Catalogue

Exhaust hood for TAYLORS'S Diesel stove 079D. The H-shaped exhaust hood prevents wind and water from entering the exhaust pipe and ensures a particularly good exhaust due to the large openings.

In addition to the accessories and spare parts listed here, we can supply other important parts from stock or order them for you at the factory.

Questions about the product?

Last seen products

More articles from this category

Wall shade inox

Wall shade inox

Small reflector plate for heat protection behind flue pipes.Plate stainless steel.Measurements:50cm high, 15cm wide.Available as flat or recessed version.The flat plate must be mounted with spacers or insulation behind, the recessed plate can be mounted directly on the wall.

From €35.90 *

Temperatur sensor pipe TAYLOR'S CTG1375

Temperatur sensor pipe TAYLOR'S CTG1375

The TAYLOR diesel stove is equipped with a flame safety valve. The thermosensor shuts off the oil supply via the magnetic valve if the flame stops burning. The thermosensor is also suitable for retrofitting older stoves.In addition to the accessories and spare parts listed here, we can supply other important parts from stock or order them for you at the factory.

€43.90 *

Temperature safety valve

Temperature safety valve

All REFLEKS heating systems with a water circuit should be equipped with this shut-off valve.The KBB fire protection valve is a compact valve in a corrosion-resistant, non-flammable design that operates purely mechanically and does not require a power supply.The temperature sensor is connected to the valve via a permanently soldered capillary line.As soon as the temperature at the sensor exceeds the set value (90°), the oil supply to the stove is immediately interrupted by the valve.The valve remains closed until the reset button is pressed.The valve can also be triggered manually by pulling the reset button.The valve (supplied with connection material for 8 mm pipes, SR 8 mm cutting ring fitting on both sides) is installed in the oil supply line directly upstream of the regulator.The temperature sensor measures the flow hot water temperature near the heater. If the set temperature (90°C) is exceeded, the oil supply is shut off immediately.To connect the sensor to the heating pipework, use a copper T-piece with two G ½" male threaded pipe fittings (please order item no. 4292-100 separately). The vertical branch of the T-piece does not have direct access to the water circuit of the heating system, but is soldered onto the water-carrying pipe and serves to accommodate the temperature sensor.Care must be taken during installation to ensure that the capillary line is not kinked under any circumstances. Length of the sensor line 200 cm.

From €99.80 *

Deck Flange HTD5245 for TAYLOR'S 075D

Deck Flange HTD5245 for TAYLOR'S 075D

Deck flange for passing the exhaust duct through the deck. The flange fits the TAYLOR'S petroleum heater 079D. In addition to the accessories and spare parts listed here, we can supply other important parts from stock or order them for you at the factory.

€179.00 *

Magnetic valve TAYLOR'S HTD5260

Magnetic valve TAYLOR'S HTD5260

The TAYLOR oil-heater is equipped with this safety feature.The temperature sensor shuts the fuel supply off, if the flame dies.Also intended for retrofitting older stoves.

€76.00 *

Contact protection TAYLOR'S HTD5385

Contact protection TAYLOR'S HTD5385

Accessories for TAYLOR'S oil heater.Additional to the parts mentioned here, all important spare parts are available from stock.We can order other parts directly from the manufacturer.Please be so free and order the detailed explosion chart or the manual as a copy.

From €156.00 *

Flue pipe TAYLOR'S

Flue pipe TAYLOR'S

Straight stainless steel exhaust pipes for TAYLOR'S diesel stove 079D and for TAYLOR'S petroleum heater 079K.In addition to the accessories and spare parts listed here, we can supply other important parts from stock or order them for you at the factory.

From €99.00 *

Flue pipe 45° TAYLOR'S HTK5610

Flue pipe 45° TAYLOR'S HTK5610

Exhaust pipes with a 45° angle for TAYLOR'S diesel heater 079D and for TAYLORS petroleum heater 079K.In addition to the accessories and spare parts listed here, we can supply other important parts from stock or order them for you at the factory.

From €62.00 *

Exhaust Hood HTK5606 for TAYLOR'S 079K

Exhaust Hood HTK5606 for TAYLOR'S 079K

Exhaust hood for TAYLORS'S diesel stove 079K. The exhaust hood prevents wind and water from entering the exhaust pipe.In addition to the accessories and spare parts listed here, we can supply other important parts from stock or order them for you at the factory.

€175.00 *

Rubber cap for through hull HTK5515 for TAYLOR'S 079K

Rubber cap for through hull HTK5515 for TAYLOR'S 079K

Rubber cap to lock the deck hull of TAYLOR'S petroleum heater 079K.In addition to the accessories and spare parts listed here, we can supply other important parts from stock or order them for you at the factory.

€37.80 *

Deck Flange HTK5561 for TAYLOR'S 075K

Deck Flange HTK5561 for TAYLOR'S 075K

Deck flange for passing the exhaust duct through the deck. The flange fits the TAYLOR'S petroleum heater 079K.In addition to the accessories and spare parts listed here, we can supply other important parts from stock or order them for you at the factory.

€172.00 *

Stainless Steel Cover HTD5265M for TAYLOR'S 079D

Stainless Steel Cover HTD5265M for TAYLOR'S 079D

Stainless steel cap to cover the deck passage, fits the diesel stove 079D.In addition to the accessories and spare parts listed here, we can supply other important parts from stock or order them for you at the factory.

€59.00 *

Fuel filter CTK1191 for TAYLOR'S appliances

Fuel filter CTK1191 for TAYLOR'S appliances

Fuel filter for all TAYLOR'S appliances, replaces the former filter CTK1185.Installation in the fuel system between tank and burner to protect the sometimes sensitive burners from contaminated fuel.Filter element made of fine metal mesh.Spare part for:TAYLOR'S 028, 029, 030, 030L Kerosene cookers and stovesTAYLOR'S 079K Kerosene heatersTAYLOR'S 079D Diesel heatersTAYLOR'S Code CTK1191Handbook Code Cookers and Stoves 13Handbook Code 079K Kerosene Heater 13Handbook Code 079D Diesel Heater 11Additional to the parts mentioned here, all important spare parts are available from stock.We can order other parts directly from the manufacturer.Please be so free and order the detailed explosion chart or the manual as a copy.

€149.00 *

Burner housing (internal oven) TAYLOR'S HTD5306

Burner housing (internal oven) TAYLOR'S HTD5306

Burner case made of stainless steel, for TAYLOR'S 079D.Is placed on the burner pot and fixed with a screw.Includes viewing window (frame, seal, glass, screws).Spare part for TAYLOR'S 079D diesel heaters.TAYLOR'S Code HTD5306Handbook Code 23Additional to the parts mentioned here, all important spare parts are available from stock.We can order other parts directly from the manufacturer.Please be so free and order the detailed explosion chart or the manual as a copy.

€384.00 *

Drip valve TAYLOR'S *HTD5251

Drip valve TAYLOR'S *HTD5251

Metering Valve (Fine Taper).Installed before the solenoid valve/drip unit. The drip valve controls the amount of fuel supplied to the burner pot.Spare part for TAYLOR'S 079D diesel heaters.TAYLOR´S Code *HTD5251Handbook Code 36Additional to the parts mentioned here, all important spare parts are available from stock.We can order other parts directly from the manufacturer.Please be so free and order the detailed explosion chart or the manual as a copy.

€186.00 *

TAYLOR'S 7 litre paraffin tank with pressure gauge + valve

TAYLOR'S 7 litre paraffin tank with pressure gauge + valve

7 litre petroleum pressure tank from TAYLOR's, e.g. for the 079K petroleum heater, the 028 petroleum cooker or the 029 petroleum cooker with grill.The tank is made of stainless steel and fitted with a bicycle valve (Dunlop or lorry valve). It has a level indicator and a pressure gauge.The pressurised tank can be mounted in any position and is connected to the heater or cooker with a copper pipe.Dimensions: 180 x 340 x 290 mm (D x L x H).

€565.00 *

Request sent successfully

Request wasn't send - a error occured. Please try again.