Go to homepage
€0.00*
Jobs
Catalogue
Quick order

STERLING power distribution ProSplitR

from €219.00*

€219.00*

Prices incl. VAT plus shipping costs

Available, delivery time: 1 - 0 Tage

In stock

model
voltage (V)
terminals
current (A)
L (mm)
B (mm)
H (mm)
weight (g)
Stk
This product uses a micro processor to monitor multiple battery banks which are being charged by an alternator, ensuring that each battery receives the power required and no current back feeds through the unit.

The engine start battery is always charged with priority over other batteries.
Batteries will also be charged when the ProSplit fails.

Very robust, waterproof (IP66) housing and LED display.

Connection for two or three batterie banks.

The diode voltage drop is only 0,6V because of using semiconductor technology.
more information
Show 13 articles
📖 View article in the TOPLICHT catalogue


Downloads

This product uses a micro processor to monitor multiple battery banks which are being charged by an alternator, ensuring that each battery receives the power required and no current back feeds through the unit.

The engine start battery is always charged with priority over other batteries.
Batteries will also be charged when the ProSplit fails.

Very robust, waterproof (IP66) housing and LED display.

Connection for two or three batterie banks.

The diode voltage drop is only 0,6V because of using semiconductor technology.
Questions about the product?

Last seen products

More articles from this category

Battery isolator STERLING
Battery isolator STERLING
High-performance diodes to isolate several batteries. The common charging of several batteries with a generator is made safer, and mutual discharge is inhibited. Hinders the mutual discharge of several batteries. Through the separating diodes, the starter battery remains fully charged when the house batteries are put under load. The charging current is automatically distributed throughout the battery bank. Through solid-state technology, the voltage drop in the diode is only approx. 0.6 V. Gold-plated output terminals. For 6 - 32 volt systems.

From €52.90 *
Details
STERLING power distribution ProSplitR
STERLING power distribution ProSplitR
This product uses a micro processor to monitor multiple battery banks which are being charged by an alternator, ensuring that each battery receives the power required and no current back feeds through the unit. The engine start battery is always charged with priority over other batteries. Batteries will also be charged when the ProSplit fails. Very robust, waterproof (IP66) housing and LED display. Connection for two or three batterie banks. The diode voltage drop is only 0,6V because of using semiconductor technology.

From €219.00 *
Details
Argo FET battery isolators VICTRON
Argo FET battery isolators VICTRON
Argo FET isolators allow, similarly to diode battery isolators, simultaneous charging of two or more batteries from one alternator (or a single output battery charger), without connecting the batteries.In contrary to diode battery isolators, FET isolators have virtually no voltage loss.Voltage drop is less than 0,02 Volt at low current and averages 0,1 Volt at higher currents.A voltage increase is not necessary when charging through Argo FET battery isolators.Make sure you use short cables and sufficient cable diametre.Measurements:L x B x H: 200 x 120 x 65mm, weight 1400g.

From €109.00 *
Details
STERLING ProLatchR Latching Relay
STERLING ProLatchR Latching Relay
Power relay with various functions and low energy consumption. Different modes can be selected. Switching voltages are freely programmable.With LED display, automatic voltage detection (12 V / 24 V) and overvoltage protection, waterproof to IP66. A remote control with additional functions, e.g. alarm, can be retrofitted. Dimensions (LxWxH): 85x90x85mmThe most important areas of application are:Battery protection relay: to disconnect the starter battery from the consumer battery when a given voltage is reached (undervoltage protection) or to disconnect the consumer battery from the consumers (deep discharge protection).Battery connection relay: connects several battery banks when a given voltage is reached and disconnects them again when the voltage falls below this. This is only possible in one direction or in both directions in the case of several energy sources (alternator, solar, wind generator).

From €149.00 *
Details