Thinfilm antifouling
2 products
SEA-LINE Thin film antifouling SILVER RACING
From
€44.90 *
Very smooth and extremely fast drying thinfilm-antifouling with PTFE non-stick technology and copper oxyds as biocide agent. For medium fouling conditions in salt water, brackish water and fresh water and lakes. Not applicable for aluminium boats. Can be applied to all under-water Epoxy primers and is compatible with PTFE antifouling like VC 17m andHempel Waterglide.Not compatible to classic hard antifouling with PTFE. Please check the compatibility chart.Yield: 11-12 m²/l. Use biocide products safely. Always read the label and product information before use. BAuA-Nr. N-74280
HEMPEL HEMPASPEED TF Thin-Film Bottom Coating
From
€44.90 *
HEMPASPEED TF is a biocide-free antifouling. It forms such a smooth surface that fouling is minimized and friction is reduced. The new hydrogel technology in the HEMPASPEED TF is a combination of thin layer and hard antifouling. That means it is as robust as a hard antifouling, but with an ultra-smooth surface. It protects against fouling and is easy to clean without chemicals. Suitable for fresh, salt and brackish water as well as for inland areas. Particularly recommended in areas where biocides may not be used or only to a limited extent (also in the Netherlands). Suitable for all sports boats with GRP, steel or aluminum hulls, also for regatta and trailer boats. Application on existing antifouling layerIt is possible to switch from a conventional antifouling to HEMPASPEED TF. The old coating (if it is still intact) does not have to be removed. A layer of HEMPEL CONVERSION Primer is then required as an intermediate layer. Two coats of HEMPASPEED TF should be applied over the primer. Application as a new coating When recoating, the substrate must first be sealed with HEMPEL LIGHT Primer before applying HEMPEL CONVERSION Primer and two coats of HEMPASPEED TF. Note the instructions on the product data sheet. A maximum of 3 months should elapse between application and putting the product in the water, ideally 30 hours at around 15°Application with brush or roller Dilute with Thinner 808 (No 3) (Art. No. 2577-020) Available in four shades: True Blue (blue), Ultimate White (white), Black (black) and Penta Gray (grey). Yield: approx. 11 m²/l.
