Skip to main content


Shock absorber made of elastic, black polymer plastic. Protects against impacts and shocks, does not discolour.

Can be attached in seconds to any line with a diameter between 10 mm and 20 mm. You can see the procedure in the photos. Can be used for mooring lines, mainsheets or anchor lines.

Optimum shock absorption when using 4 pieces next to each other, or 6 pieces for longer mooring times.

Two shock absorbers are recommended for use in the mainsheet.

Supplied as a set of 2.


Last seen products

More articles from this category

FORSHEDA Mooring compensator
Proven mooring compensator made of very elastic, weather- and seawater-resistant, black EPDM rubber - boat and ropes are protected.With very effective rope clamping mechanism. The line can be easily fitted and adjusted around the mooring compensator.The damping can be adjusted based on the number of wraps.Installation instructions and information on determining the additional cordage consumption can be found in the data sheet further down on this page under "Downloads & Information".

From €19.95 *
UNIMER U-Cleat mooring compensator
Patented, highly elasticated mooring compensator with removable, high-strength clamping bridges (U-Cleats) at the ends. This allows the mooring compensator to be easily attached to a mooring line or repositioned without having to pull one end of the line through.Material: particularly weather- and seawater-resistant EPDM rubber.

From €34.90 *
Mooring Compensator
Mooring compensator made from seawater-proof and UV-resistant EPDM rubber.Very simple mounting (slides onto the docklines) and good efficacy.Colour: black.

From €10.95 *
BUNGY Mooring compensator
Shock absorber made of elastic, black polymer plastic. Protects against impacts and shocks, does not discolour.Can be attached in seconds to any line with a diameter between 10 mm and 20 mm. You can see the procedure in the photos. Can be used for mooring lines, mainsheets or anchor lines.Optimum shock absorption when using 4 pieces next to each other, or 6 pieces for longer mooring times. Two shock absorbers are recommended for use in the mainsheet.Supplied as a set of 2.

€18.90 *
Mooring Spring / Mooring Compensator
Very stable mooring compensator made of A4 stainless steel (AISI 316).The mooring spring is particularly suitable for permanently installed mooring lines in problematic, unprotected berths with a lot of swell.The jerk springs are also suitable for high ship weights (see specifications in the table below).

From €13.95 *